debug test-call
This command initiates and terminates a call from the device to a remote destination to test whether connectivity, media, etc., are correct. Sends a SIP INVITE message and then manages the call with the call recipient.
Syntax
debug test-call ip
|
■
|
Configures a test call: |
debug test-call ip dial from {<Calling Number> to <Called Number> [dest-address <IP Address>] [sip-interface <SIP Interface ID>]|id <Test Call Table Index>}
|
■
|
Configures a test call: |
debug test-call ip set called-number <Called number> caller-id <Caller ID> calling-number <Calling number>dest-address
<IP Address> play <Playback> sip-interfaces <SIP Interface ID> timeout <Disconnection timeout> transport-type
|
■
|
Terminates a test call: |
debug test-call ip drop {<Calling Number>|id <Test Call Table Index>}
|
■
|
Displays test call configuration: |
debug test-call ip show
|
|
|
|
ip
|
Configures and initiates a test call to an IP address.
|
■
|
dial (Dials using specified parameters) |
|
✔
|
from (Defines the calling number): |
|
✔
|
[NUMBER] (Calling number) |
|
✔
|
id (uses the Test Call Rules table entry) |
|
■
|
drop (Terminates the latest outgoing test call): |
|
✔
|
[Calling Number] (Terminates outgoing test call by number) |
|
✔
|
id (Terminates outgoing test calls by table index) |
|
■
|
set (Sets test options): |
|
✔
|
called-number (Called number) |
|
✔
|
calling-number (Calling number) |
|
✔
|
dest-address (Target host) |
|
✔
|
sip-interfaces (Sets SIP interfaces to listen on) |
|
✔
|
timeout (Disconnection timeout (seconds)) |
|
✔
|
transport-type (Transport type) |
|
■
|
show (Displays test call configuration) |
|
Command Mode
Basic and Privileged User
Note
|
■
|
The command is applicable only to the SBC application. |
|
■
|
Test calls can be made with the following two recommended commands: |
|
●
|
(Basic) Making a call from one phone number to another, without performing any configuration: |
debug test-call ip dial from * to * dest-address * [sip-interface *]
|
●
|
(Advanced) Configuring a row in the Test Call table, and then placing a call by the row index: |
debug test-call ip dial from id *